Janome Model MC11000 Tension Unit Service
Janome Model MC11000 thread cutter unit service
Janome Model MC11000 Top Cover Removal
Janome Model MC11000 top cover attachment and bobbin winder
Janome Model MC11000 Upper & Lower Shaft Timing
Janome Model MC11000 LCD Removal and Replacement
Janome Model MC11000 SCREEN CALIBRATION
Janome Model MC11000 stretch stitch balance adjustment
Janome Model MC11000 PRESSURE FOOT SENSOR Adjustment
Janome Model MC11000 Needle To Hook Timing
Janome Model MC11000 Needle to Hook Clearance
Janome Model MC11000 NEEDLE THREADER PLATE ADJUSTMENT
Janome Model MC11000 Front Panel Removal
Janome Model MC11000 Hook Backlash
Janome Model MC11000 Main Motor and Replacement
Janome Model MC11000 Needle Threader Motor Attachment
Janome Model MC11000 Needle Bar Height
Janome Model MC11000 needle threader motor removal
Janome Model MC11000 Lower Shaft Observation
Janome Model MC11000 Jump Thread Trim Upgrade Parts
Janome Model MC11000 foot up down micro switch adjustment
Janome Model MC11000 Belt Cover Removal
Janome Model MC11000 Belt cover attachment
Janome Model MC11000 BOBBIN GAUGE SET
Janome Model MC11000 Center Needle Position
Janome Model MC11000 BUTTONHOLE ADJUSTMENT
Janome Model MC11000 Front Panel Attachment
Janome Model MC11000 BASE UNIT COVERS X MOTOR BELT REPLACEMENT Y RELEASE ARM
Janome Model MC11000 A Board Installation
Janome Model MC11000 A Board Removal
Janome Model MC11000 Base Sensor adjustment
Janome Model MC11000 Base Unit Removal
Janome Model MC11000 Bed Cover Removal
Janome Model MC11000 BASE COVERS,BED COVER,BASE ATTACHMENT
greetings: This is a wonderful site, excellent resource for sewing machine repair and troubleshooting, I have a strange problem, I have a janome mc 10001 just upgraded to 10001. Now it seems when in embroidery mode the tension is not working, but it sews beautifully in regular mode, The tension seemed to work before the upgrade? I took off the top of the tensioner and when I set the tension on the screen the wheel doesn’t move, only moves when in regular sewing mode. So I am not sure what is wrong, when in embroidery mode the it birds nest under the fabric, and the tension settings don’t seem to work? Also reloaded the new software several times to be sure. Is there some type of something I can repair it. Also the thread is in the tension discs and changed from embroidery mode to regular sewing mode to be sure and back. I’m going to remove the top cover and re clean the connectors for the tension unit. Is there separate wiring on the tension unit for the embroidery mode? Any input would be really helpful.
thanks again
Bob Lenig